Features
The two gear adjustment position is convenient to use.
Forged with high-quality carbon steel, the surface is not easy to be corroded after nickel plated.
The handle of composite ergonomics is adopted, saving time and effort.
Specifications
Model No |
Size |
|
110920006 |
150mm |
6" |
110920008 |
200mm |
8" |
110920010 |
250mm |
10" |
Product Display
Application of slip joint plier
It is used to clamp round parts, and can also replace the wrench to screw small nuts and bolts. The rear edge of the jaw can be used to cut off metal wires, which is widely used in the automobile repair industry. It can also be used for water pipe maintenance, equipment maintenance, handle maintenance, tool maintenance and maintenance clamping.
Usage method of slip joint pliers
Change the position of the hole on the fulcrum so that the opening degree of the jaw can be adjusted.
The jaw can be used for clamping or pulling.
Thin wires can be cut at the neck.
Tips
Cognition of slip joint pliers:
The front part of slip joint pliers is flat and fine teeth, which is suitable for pinching small parts. The middle notch is thick and long, which is used for clamping cylindrical parts. It can also replace the wrench to screw small bolts and nuts. The cutting edge at the back of the jaw can cut the metal wire. Since there are two holes that connect with each other on a piece of pliers and a special pin, the opening of the jaw can be easily changed during operation to adapt to clamping parts of different sizes, It is the most widely used hand clamp in automobile assembly. The specifications are expressed in terms of tong length, generally 150mm and 200 mm.